Tag Archive: eagle

AVR ATmega328P Project Board – Part 3 – PCB Parts Fine Tuning Placement

Okay, quick followup post looking at the fine tuning the placement of parts on the 50x50mm PCB board. We continue where we left off last, in part 2. Time Table of Contents 00:00 – Intro 00:09 – Start adjusting placement of ICSP, Reset Switch, and LED 00:58 – Adjust ADC/I2C Header Placement 02:48 – Adjust GPIO Header Placement 03:29 – Adjust XTAL and capacitors 03:55 – Adjust decoupling capacitors 04:57 – Tweaking and adjusting of ICSP, Reset Button, and LED 05:45 – Fine tune placement of headers with Information tool 06:11 – Move ICSP and reset button away from edge of the board 06:55 – Adding copyright marking on the board 07:53 – More fine tuning placements with Information tool. 08:35 – Credits Roll

AVR ATmega328P Project Board Schematic Creation

So this video runs a bit long, over 40 minutes. I would have broken it up or montaged it, but I wanted to be able to provide information with the option of skipping ahead. This is a beginning to end video of the schematic for the ATmega328P board being created in Autodesk Eagle PCB Design software. All of the parts used in the design are through hole parts and the resources used are listed below. Information From Video Posting So this video runs a bit long, over 40 minutes. I would have broken it up or montaged it, but I wanted to be able to provide information with the option of skipping ahead. This is a beginning to end video of the schematic for the ATmega328P board being…
Read more

%d bloggers like this: